22
7. Pull the rope until the engine starts.
8. Run the machine for 30 seconds at idle speed, press the
throttle lock (7), then hold throttle level (8).
24
7
6
8
9. Adjusting line length while working:
This machine is fitted with a ‘Tap & Go’ head. To release more
line, tap the cutting line head against the ground with the
engine at top speed; the line will be released automatically and
the knife will cut off the excess length.
10. If you encounter any problems, turn the engine switch to the ‘O’
position to turn off the engine and the machine will stop.
11. If any problem occurs, pull the pin of the safety strap, then
release the brush cutter immediately.
12. If the machine is hot, the throttle level can be adjusted to the ‘I’
position directly when the machine is restarted.
NOTE: If the engine does not start up after several attempts, read
the section ‘Troubleshooting’.
To Next Page
Loading...