PowerBase 577174 - Troubleshooting

40
TROUBLESHOOTING
Problem Possible cause Solution
Product does
not start
• Battery pack not
properly attached
• Battery pack dis
-
charged
• Battery pack dam
-
aged
• Other electrical defect
to the product
• Atach properly
• Remove and charge
the battery pack
• Check by a specialist
electrician
• Check by a specialist
electrician
Product does
not reach full
power
• Battery pack capacity
too low
• Air vents are blocked
• Remove and charge
the battery pack
• Clean the air vents
Unsatisfactory
result
• Accessory is worn
• Accessory not suit
-
able for intended op-
eration
• Replace with a new one
• Use suitable accessory
Product sud
-
denly stops
• Product overloaded
• Battery pack dis
-
charged
• Battery pack too hot
• Remove the product
from the workpiece and
switch it on again
• Remove and charge
the battery pack
• Remove the battery
pack and let it cool
down
Excessive
vibration or
noise
• Accessory is dull /
damaged
• Bolts/nuts are loose
• Replace with a new one
• Tighten bolts/nuts