To Next PageTo Next PageWhat to do if my PowerBase 638713 Chainsaw suddenly stops?
If your PowerBase Chainsaw suddenly stops, it might be due to overloading. Remove the chainsaw from the workpiece and switch it on again. Alternatively, the battery pack might be discharged. In this case, remove and charge the battery pack. Finally, the battery pack could be too hot; remove it and allow it to cool down.
How to troubleshoot a PowerBase 638713 Chainsaw that does not start?
If your PowerBase Chainsaw doesn't start, it could be due to several reasons. First, ensure the battery pack is properly attached; if not, attach it correctly. Second, the battery pack may be discharged; remove it and charge it. It is also possible that the battery pack is damaged or there is another electrical defect. In these cases, it is recommended to have it checked by a specialist electrician.
Why is my PowerBase 638713 Chainsaw not reaching full power?
If your PowerBase Chainsaw is not reaching full power, it could be due to a low battery pack capacity. Remove and charge the battery pack to resolve this. Another possible reason is that the air vents are blocked. Make sure to clean the air vents.
General
