24
Filling oil tank
i. Take off the oil cap and put the lubrication oil into the oil tank
until the oil level up to the ‘MAX.’ line.
ii. Attach the oil cap and press the compresession cap
continuously for 3-4 times before first use. During the operation,
press the cap for 1 or 2 times after every 5 cuts
,
to make sure
the the chain is being continuously lubricated.
WARNING! The product is not filled with oil. It is essential
to fill the product with oil before using it! Never operate the
product without chain oil or with an empty oil tank, as this will
result in extensive damage to the product!
WARNING! Remove the battery pack before filling the
oil tank.
NOTE: Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain
should be oiled before operation.
NOTE: Do not use force when installing the battery pack.
If the battery pack does not slide in easily, it is not being
inserted correctly.
x 4
Saw Chain Tension Adjustment
1. Remove the battery pack and wear the protective gloves.
2. Place the chainsaw on any suitable flat surface.
3. Adjust the chain tension, turn the tension wheel clockwise
to tighten.
Loosen
Tighten
To Next Page
Loading...
