25
Charging the battery
WARNING!
The charger and battery pack are specifically designed to
work together, so do not attempt to use any other devices.
Never insert or allow metallic objects into your charger or
battery pack connections; an electrical failure and hazard
will occur.
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that
were easily done before.
WARNING! NEVER LEAVE THE BATTERY AND CHARGER
UNATTENDED WHEN CHARGING THE BATTERY.
This product comes with a lithium-ion battery pack.
Lithium-ion batteries don’t lose charge when not in use,
and don’t lose charging capacity over time. Nevertheless,
it is best practice to charge the battery when empty or
insufficient to do the job.
The charging procedure
WARNING! The battery cannot be charged
immediately after use, it should cool down for 30 minutes.
The LED light (8) switching from green to red means it is
being charged.
1. Connect the charger (7) to a power supply. The left red light (8)
will illuminate.
2. Slide the battery pack into the charger, make sure the battery
pack (6) is fully seated in position. The left red right is on and
the right green light (9) is flashing to indicate the charging is
on-going.
3. When charging is complete, the left light is off and the right
green light is on.
4. Once the battery is fully charged , disconnect the charger from
the mains and remove the battery pack from the charger.
6
8
9
7
To Next Page
Loading...
