PowerBase 638713 - Noise and Vibration Data

39
Noise emission value:
Noise measurement value determined in accordance with EN 62841.
The A-rated noise level of the power tool is typically as follows:
Sound pressure level L
PA
: 75.9dB(A)
Uncertainty k= 3 dB(A)
Sound power level L
WA
: 86.9dB(A)
Uncertainty k= 3 dB(A)
Guaranteed sound power level L
WA
: 90dB(A)
The vibration level varies in accordance with the use of the power
tool and may, in some cases, be higher than the value specified
in these instructions. There is a risk of under-estimation of the
vibration load, if the power tool is used regularly in this manner. Try
to keep the vibration loads as low as possible. Measures to reduce
the vibration load are, for example, wearing gloves and limiting the
working time (e.g. times when the power tool is switched off and
times where the power tool is switched on, but running without load).
Technical Data
NOTE:
The vibration level specified in these instructions has been
measured in accordance with a standardised measuring
procedure specified in EN 62841 and can be used to make
equipment comparisons. The specified vibration emission
value can also be used to make an initial exposure estimate.
WARNING! This equipment may cause Hand-Arm Vibration
Syndrome (HAVS) if its use is not adequately monitored
and managed.
Preventative measures include, among others, regular
maintenance and care of the product and cutting
attachments, keeping hands warm and periodical breaks, as
well as proper planning of work processes.