EasyManuals Logo

PowerBox Systems GPS III User Manual

PowerBox Systems GPS III
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4 PowerBox-Systems − World Leaders in RC Power Supply Systems
2. FIRST USE
As already mentioned, the GPS III automatically detects the system to which it is
connected. This applies both to internal PowerBox protocols and those of other
manufacturers. When rst plugged in, the unit may take a few seconds to detect
the connected telemetry system. This information is then stored, and will automati-
cally be set next time the system is switched on.
- CORE P²BUS
If you intend to use the GPS III purely as a telemetry sensor, you should plug it
directly into the receiver’s P²BUS input; the system will be detected automatically.
You may nd that a rescan is required the rst time you switch on after connecting
the unit.
- Royal SRS / Mercury SRS / iGyro SRS / iGyro 3xtra
Connect the GPS to the GPS or MISC input as appropriate. The system will be
detected automatically, and is immediately ready for use. If you are using a Royal
or Mercury, you should see the GPS data displayed on your transmitter. With imme-
diate effect, the installed gyro now operates with speed compensation.
- Jeti EX-BUS
A new feature of the GPS III is inclusion of the faster Jeti Ex-BUS protocol; the
Jeti-Box protocol is no longer implemented. Please switch one of the receiver’s
Telemetry inputs to Jeti Ex-BUS from the transmitter, and connect the GPS III to
that socket. The protocol will be detected automatically, and you will see all the
GPS data in your sensor list.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PowerBox Systems GPS III and is the answer not in the manual?

PowerBox Systems GPS III Specifications

General IconGeneral
BrandPowerBox Systems
ModelGPS III
CategoryMeasuring Instruments
LanguageEnglish