9 GB/IE
Remove dead batteries from the device
immediately!
Before using
Before initial use, remove the protective film
from the device display
2
and insert the
enclosed battery.
Inserting / changing
the battery
If the battery symbol
9
appears in the
display, the inserted battery is almost drained
and must be replaced. Empty batteries can falsify
the measured result.
To insert the battery proceed as follows:
Open the battery compartment cover on the
back of the device. You can remove the used
battery more easily with the aid of the mate-
rial strip, which is inside the battery compart-
ment
6
. Just pull on the material strip.
Remove the used battery.
Plug the contacts of the 9 V block battery on
the contacts of the profiled plug. Make sure
you fit the batteries the right way round. This
is specified by the profiled shape of the con-
tacts. Also ensure without fail that the mate-
rial strip is underneath the battery.
Insert the battery in the battery compartment
and close the cover again, so that it audibly
latches into place.
To Next Page
Loading...
