Adding volumes together
1. Measure a volume as described in the section
"Measuring volumes".
2. Press and hold down the MODE 9 button.
"M+" appears in the display w. The volume measured
is now saved.
3 Press the MODE 9 button. The device is now ready
for the second measurement.
4. Measure the next volume.
5. Press the RECALL 5 button. A "+" appears in the display.
6 Press and hold down the RECALL 5 button. In the lower
line is shown the result of the first measurement.
7. Press the button RECALL 5. The two measurements
will be added together and the result indicated on the
lower line.
8. Repeat the steps 2 to 7 to add together further
measurements.
9. Should you wish to depart the addition mode, press the
button MODE 9. All values will be erased.
Displaying the last measurements
After the measurement of a total distance, an area or a
volume, press the button READ q repeatedly to indicate
once again the individual values of the measurements.
The beam of the respective measured value blinks and the
measurement result is indicated in the upper line of the
display w.
Temperature Display
Press and hold down the FT/M 4 button. In the display w
the temperature indicator appears in the lower line.
To change between the SI unit system (degrees celcius)
and the Angloamerican system (degrees Fahrenheit) press
the FT/M 4 button. If you want to exit the temperature
indicator press the MODE 9 button.
- 9 -
To Next Page
Loading...
Need help?
General
