Powerfix Profi PMDL 5 A1 User Manual

Adding distances together
You can add the measured distances together:
1. Measure the first distance as described.
2. Press the button +/=
r
. In the display
2
, „+“ appears and the distance
measured carries itself over to the lower line.
3. Measure the next distance. The newly measured distance is shown in the
upper line.
4. Once again, press the button +/=
r
. The new measurement is added
to the old measurement in the lower line.
5. Repeat steps 2 to 4 to add further measurements.
6. When you wish to leave the addition mode, press the button MODE
7
.
All values are erased.
Measuring areas
1. Slide the function switch
q
to „DISTANCE“.
The display
2
switches itself on.
2. Press the button MODE
7
once. In the display
2
flashes „L“ (Length).
3. Press the button READ
6
, to measure the length. In the upper line
the measured length appears and „W“ (Width) starts to flash.
4. Press the button READ
6
to measure the width. The measured width
appears on the upper line and the result of the area calculation in the
lower line.
Adding areas together
1. Measure an area as described in the section „Measuring areas“.
2. Press the button M
4
. „M+“ appears in the display
2
. The area measured
is now saved.
3. Press the button MODE
7
. The appliance is now ready for the second
measurement.
4. Measure the next area.
5. Press the button +/=
r
. A „+“ appears in the display
2
.
6. Press the button RM
w
. The result of the first measurement is shown in
the lower line.
7. Press the button +/=
r
. Both measurements are added together and
the result is shown in the lower line.
8. Repeat the steps 2 to 7 to add in further measurement values.
9. When you wish to leave the addition mode, press the button MODE
7
.
All values are erased.
- 7 -

Powerfix Profi PMDL 5 A1 Specifications

General

Brand	Powerfix Profi
Model	PMDL 5 A1
Category	Security Sensors
Language	English