PowerMaster PM-3500 - Operation; Starting the Engine; Recoil Start; Electric Start

13
6. OPERATION
NOTE: ───────────────────────
z The generator has been shipped without engine oil. Fill with oil or it
will not start.
z Do not tilt the generator when adding engine oil. This could result in
overfilling and damage to the engine
───────────────────────────
1）STARTING THE ENGINE
NOTE: ─────────────────────
z Only connect the electrical appliances after you have started the
generator.
─────────────────────────
A Recoil start
1. Open the fuel tank air vent to the “OPEN” position.
2. Turn the fuel cock lever to the “ON” position.
3. Turn the engine switch to the “ON” or “RUN” position.
4. Turn the choke lever to the “│ │”position. Not necessary if the
engine is electric type.
5. Pull the starter handle slowly until resistance is felt. This is the
“Compression” point. Return the handle to its original position and
pull swiftly. Do not fully pull out the rope. After starting, allow the
starter handle to return to its original position while still holding the
handle. Grasp the carrying handle firmly to prevent the generator
from falling over when pulling the recoil starter.
6. Warm up the engine.
7. Turn the choke lever back to the operating position. Not necessary
if the engine is electric type.
8. Always warm up the engine without a load for a few minutes.
B Electric Start
1. Open the fuel tank air vent to the “OPEN” position.
2. Turn the fuel cock lever to the “ON” position.
3. Turn the engine switch to the “START” position.
OPEN
ON
ON
STOP
ENGINE
SWITCH
S T O P
R U N
S T A R T
ENGINE
SWITCH