Questions? Call Toll Free at 1-800-737-2112 Copyright © 2011 MAT Engine Technologies, LLC
Operation (Continued)
• Save all instructions
Engine Break-In Period:
H
8
During he firs en (10) hours of use use he slowes engine speed which allows for effec ive cu ing and avoid opera ion
a high engine speeds for ex ended periods of ime
This will maximize he life and performance of your cul iva or s engine Maximum power will be achieved af er he firs en
(10) hours of engine opera ion
Fig. 11
The drag s ake adds resis ance when cul iva ing which
makes he uni easier o con rol also can be adjus ed o
change he dep h of cul iva ing To adjus he drag s ake
posi ion follow he s eps below and refer o Figure 11
1 Remove he de en pin
2 Slide he s ake o he desired posi ion aligning he hole
in he s ake wi h he holes in he suppor bracke
3 nser he de en pin hrough he holes o secure he
drag s ake
No e For he deepes cul iva ing dep h se he drag s ake
in i s lowes posi ion This will give he grea es resis ance
and allow for he deepes dep h
Adjusting the Drag Stake Position:
F
1 Loosen knob
2 Move he wheels up or down
NOTE he upper posi ion is for cul iva ing he lower
posi ion is for ranspor
3 Tigh en knob securely af er adjus ing he wheels o he
desired heigh
Adjusting the Wheel Height:
G
Starting Engine (Continued):
C
Adjusting Engine Speed:
D
If the unit still doesn’t start, refer to the
TROUBLESHOOTING section of this manual or:
If you need assistance or have any questions,
CALL TOLL FREE: 1-800–737-2112
Starting a Flooded Engine
1 Place he cul iva or on a fla surface
2 Move he igni ion swi ch o he ON posi ion
3 Move he choke lever o he ‘run/ warm s ar posi ion
(see Figure 7)
4 Hold he hro le rigger fully depressed in fas posi ion
(See Figure 10)
5 Pull he recoil s ar er handle repea edly un il engine
s ar s and runs This could require pulling he recoil
s ar er handle many imes depending on how badly he
uni is flooded
6 f he engine s ill does no s ar allow he uni o si for
abou 15 minu es and repea s eps 1 5
No e his cul iva or is equipped wi h a cen rifugal clu ch so he ines will no urn un il he engine speed is increased
To increase he engine speed lif up on he hro le rigger (See Figure 10)
To slow he engine down slowly release he hro le rigger Comple ely releasing he hro le lever will re urn he engine o
idle and will s op he ines from ro a ing
1 Release he hro le rigger and allow he engine o idle for a few momen s (See Figure 10)
2 Push and hold he igni ion swi ch o he ‘s op posi ion (See Figure 6)
Stopping the Engine:
E
Fig. 10
FAST
SLOW
Drag s ake
De en Pin
Holes
Suppor Bracke
To Next Page
Loading...
Need help?
General
