Powermatic BD31A - Specifications

7
SPECIFICATIONS: Model 31A Sander
FIGURE 1
Disc size...................................................................................................................................................................12”
Disc speed.....................................................................................................................................................2378 RPM
Sanding belt size ........................................................................................................................................6” W x 48” L
Upper & lower wheel......................................................................................................................4-3/8” Dia. x 6-1/4” L
Belt speed .....................................................................................................................................2409 feet per minute
Motor..................................................................................................1-1/2 HP, 1 Ph, 115/230V, 12/6 Amp, 1750 RPM
Belt position................................................................................................................................ 0 , 45, and 90 degrees
Table size – disc................................................................................................................................... 14-1/2” x 6-1/2”
Disc table tilt ............................................................................................................15 degrees up to 45 degrees down
Fence table tilt ...........................................................................................................0 degrees up to 45 degrees down
Fence size............................................................................................................................................13” W x 7-1/2” L
Net weight ......................................................................................................................................................246.4 lbs.
NOTE: The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Powermatic reserves the right to change specifications without notice and without
incurring obligations.