EasyManua.ls Logo

PowerOak PS7 - Frequently Asked Questions (FAQ); Checking Charge State; Charging Other Devices; Depth of Discharge (DOD)

PowerOak PS7
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PS 7 User Manual
Kanaaldijk Noord 111 | 5642 JA | Eindhoven | Nederland
Page 14 of 44
©2018 PowerOak B.V. Netherlands
E15
Section 2 battery
core low voltage
Single-cell voltage ≤ 2.8V
Charge, voltage≥ 3.0V, self-
recovery
E16
Section 3 battery
core low voltage
Single-cell voltage ≤ 2.8V
Charge, voltage≥ 3.0V, self-
recovery
E17
Section 4 battery
core low voltage
Single-cell voltage ≤ 2.8V
Charge, voltage≥ 3.0V, self-
recovery
E18
PV input over voltage
PV voltage≥ 40V
PV voltage≤ 38V,self-recovery
E20
PV output over
current
Charge current>10A
Remove PV, charge recovery
E26
DC12V output
overload
DC12V load > 145W
Remove load, restart DC
E34
System overloaded,
turn off DC
Total power>680W
Remove load, restart DC
E36
Inverter output
overload
Inverter overload
Remove load, restart AC
E37
Inverter output
overcurrent
Inverter overload or short-
circuit
Remove load, restart AC
E38
System overload,
turn off AC
Total power>680W
Remove load, restart AC
Note: The protection values set above are all theoretical values, and there will be
slight deviation from the actual protection values, this is normal.
8. Frequently Asked Questions and Answers(FAQ)
How to check the state of charge?
The battery icon display on the LCD display shows the battery level and charge status.
How to use the product to charge other electronic devices?
(1) Check the user manual or search for such information online to learn about the
charging parameters of the electronic devices.
(2) Check the power of each output port. For example, the maximum rated output
power of the AC output port is 600W, This means that if the power of the connected
electronic device exceeds 600W for a long time, the inverter will turn off the output.
●What is the depth of discharge (DOD)?
To prolong the battery life, the product has a DOD setting to 90%, which means that only
90% of the battery capacity can be discharged, and retain 10% to avoid damage to the
battery due to excessive discharge.
●Can it charge and discharge simultaneously?
Yes, but it is not recommended to charge and discharge at the same time in order to
protect the battery life.

Related product manuals