Powerplus POWEG7010 - Troubleshooting; Technical Data

POWEG7010 EN
Copyright © 2017 VARO P a g e | 10 www.varo.com
At the end of the season, or if the application is not to be used for longer than a month:
 Clean the application.
 Wipe over all metal surfaces with an oil-impregnated cloth to protect them from corrosion
(non-resinous oil), or spray a fine coat of oil onto them from a can.
 Fold the guide bar down, and store it in a suitable place.
13 TROUBLE SHOOTING
Problem
Possible causes
Remedy
Motor does not
start
No electricity
Check mains connection
Defective cable
Check cable, plug in, replace if
required, or have it repaired by a
qualified person
Defective safety switch/ trigger
lever combination
Arrange for repair in a specialist
workshop
Overheat protection activated
Working depth too large, set to the
shorter depth
Blades blocked, remover the
blockage
Soil too hard, select correct work
depth and forwards and
backwards several times while
slowly down the operation speed
Wait till the motor cool down for
around 15 minutes before rework
Abnormal noises
Blade is jammed
Switch off wait till complete stop.
Remove the objects
Lubrication running out
Arrange for repair in a specialist
workshop
Loose bolts, nuts or other
securing components
Tighten all components, contact
specialist workshop if noises
prevail
Abnormal
vibrations
Blades damaged or worn
Replace or have it checked by an
specialist workshop
Working depth too large
Set to correct working depth
Poor scarification
results
Working depth too small
Set to correct working depth
Worn blades
Replace or have it checked by an
specialist workshop
14 TECHNICAL DATA
Power supply voltage:
230-240V~ 50 Hz
Power consumption:
1050 W
Idle Speed:
380 min-1
Working width:
320 mm
Working depth max.:
220 mm
15 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
80 dB(A)
Acoustic power level LwA
93 dB(A)