POWX0460 EN
Copyright © 2022 VARO P a g e | 4 www.varo.com
▪ Do not overreach. Keep proper footing and balance at all times. This enables better
control of the power tool in unexpected situations.
▪ Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewelry or long hair can be caught in moving
parts.
▪ If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used. Use of these devices can reduce dust related
hazards.
5.4 Power tool use and care
▪ Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
▪ Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
▪ Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
▪ Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
▪ Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
▪ Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
▪ Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
5.5 Service
▪ Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 ADDITIONAL SAFETYHINTS FOR BELT SANDERS
Always wear safetygoggles and a dustmask during your work with the
sander.
Observe the applicable regulations when sanding painted surfaces.
Take special care when sanding lead based paint:
▪ All persons entering the work area must wear a mask specially designed for protection
against lead paint dust and fumes.
▪ Children and pregnant women must not enter the work area.
▪ Do not eat, drink or smoke in the work area.
▪ Whenever possible, use a vacuum extractor for dust collection.
▪ Remove dust and other waste matter in an environmentally safe way.
▪ Always secure the work piece by clamps or else to avoid slipping away.
▪ Do not leave the tool running. Operate the tool only when handheld.
To Next Page
Loading...