12
ADJUSTING THE CUTTING HEIGHT
Warning! Cutting height adjustments should only be performed after the engine and blades
have come to a complete stop!
It is always best to begin cutting your lawn with a higher deck height to prevent scalping your lawn.
The cutting height is adjusted with a single lever.
Actuate the adjustment lever and pull it to the required position. Please make sure that the lever locks into
position.
OPERATION
GAS AND OIL FILL-UP
The engine comes shipped without oil or gasoline. Be sure to add oil and gasoline before starting the
engine.
1. Add oil before starting mower for the first time.
2. Service the engine with gasoline as instructed.
Warning: Use extreme care when handling gasoline. Gasoline is extremely flammable and
its vapors are explosive. Never fuel the machine indoors or while the engine is hot or running.
Extinguish all cigarettes, cigars, pipes and other potential sources of ignition.
ADD OIL
The engine is shipped without oil. User must add the proper amount of oil before operating the engine for
the first time .The oil capacity of the engine crankcase is 16.9fl.oz. For general use (above 40 °F),we
recommend 30W,4-stroke engine oil.
ENGINE OIL RECOMMENDATIONS
Oil is a major factor effecting performance and service life. We recommend the use of a good detergent
automotive oil.30W is recommended for most applications. Other viscosity grades shown below may be
acceptable for use in these engines.
Cutting height adjustment lever
To Next Page
Loading...
