Drive Control Lever
Located on the right side of the upper handle, the Drive Control Handle is used to engage and
disengage the drive wheels. Squeeze the Drive Control Handle against the upper handle to engage the
wheels; release to disengage.
Drive Speed/Gear Control
The Speed/Gear Control is located on the center of the panel and is used to set the drive speed and
direction of travel. It can be moved into any of eight positions (six forward and two reverse gear
settings)
Auger Control Lever
Located on the left side of the upper handle, the Auger Control Handle is used to engage and
disengage the augers. Squeeze the Auger Control Handle to engage the augers; release to disengage
the augers.
Chute Rotation Handle
To adjust snow discharge direction, rotate the handle clockwise or counter-clockwise…. should
rotate 180 degrees.
Skid Shoe
Position the shoes based on the surface conditions. Adjust upward for hard-packed snow. Adjust
downward when operating on gravel or crushed rock surfaces.
To Next Page
Loading...
