GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use of
any other parts may create a hazard or cause product damage.
To ensure safety and reliability, all repairs should be performed
by a qualified service technician.
MAINTENANCE
8
MAINTENANCE
8
WARNING
Keep the table saw crosscut sled dry, clean, and free from oil
and grease. Always use a clean cloth when cleaning. Never
use brake fluids, gasoline, petroleum based products or any
strong solvent to clean the table saw crosscut sled. Chemicals
can damage, weaken or destroy plastic which may result in
serious personal injury.
OPERATION
8
To Convert from Inboard to Outboard Position
Remove the knob and T-Bolt and rotate the stop body 180°.
Replace the knob and T-bolt. See Figure 17.
inboard outboardtransition
Figure 17
Knob
Stop Body
T-Bolt
To Next Page
Loading...
