3
ASSEMBLY
ASSEMBLY
3
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether all
parts and accessories are included.
ITEM DESCRIPTION QTY
A
MDF sled 1
B
MDF fence face 1
C
Extruded Fence 1
D
Miter bar 1
E
3" Flip stop (Powertec 71367) 1
F
5-1/2" Hold down clamp with hardware
(Powertec 71083)
1
G
Five star knob, 2" in diameter 1
H
5/16"-18 round knobs (3/4" tall) 3
I
5/16"-18 x 1" T-Bolts 3
J
5/16"-18 x 1-1/2" T-Bolts 1
K
Flat head Phillips screws 1/4"-20 x 3/4" 5
L
Cursor with two M4 x 1/4" screws 1
M
Seven star knob
(2" in diameter with 5/16"-18 x 5/8" stud)
1
N
Slotted nylon adjustment screws 8
O
Nylon bushing 1
P
4 mm hex wrench 1
Q
Adjustable stop 1
R
Wear resistant strip (long) 3
S
Small screwdriver (for miter bar adjustments) 1
Figure 1
H
K
M
B
N
C
P
G
F
L
J
E
I
D
A
R
S
O
Q
WARNING
Do not use the table saw crosscut sled until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool being
used with this table saw crosscut sled.
To Next Page
Loading...
