PowerTec AF4001 User Manual (English)

Questions and Answers:

N
ncoxAug 3, 2025
Why is my PowerTec Water Filtration Systems vibrating or noisy?
- B
  Brian GrahamAug 4, 2025
  If your PowerTec Water Filtration System is experiencing excessive vibration or noise, start by inspecting all hardware to ensure it's tightened or replaced if necessary. Check the motor fan to make sure it's not rubbing against the cover; adjust its position or replace any loose or damaged parts. Also, inspect and reposition the air filters. Furthermore, turn off and unplug the machine to inspect the impeller for bent or damaged areas, securing it on the motor shaft or replacing it if damaged. Finally, tighten any loose fasteners on the motor base within the cabinet. If the motor bearings are loud, rotate the motor shaft to isolate the issue and replace worn bearings.
S
Sabrina RobinsonAug 9, 2025
What to do if the PowerTec Water Filtration Systems fuse blows or circuit breaker trips?
- D
  durhamwilliamAug 9, 2025
  If the fuse blows or the circuit breaker trips on your PowerTec Water Filtration System, it may be due to an overloaded electrical circuit. Try reducing the number of items on the circuit. It could also be due to the wrong fuse or circuit breaker being installed, in which case you should replace it with the correct one. Finally, check if you are using an undersized or excessively long extension cord and replace it with the correct size.
S
simmonscarlosAug 16, 2025
Why does my PowerTec Water Filtration Systems motor stall or lack power?
- L
  Laurie MossAug 16, 2025
  If your PowerTec Water Filtration System motor stalls or lacks full power, have a qualified electrician check the circuit for proper voltage, as an incorrect line voltage could be the cause. Another potential cause is a failed motor capacitor, which would need to be replaced. Also, inspect or replace the control panel circuit board if it has failed.
R
Rebecca JohnsonAug 21, 2025
Why does PowerTec Water Filtration Systems have poor air flow and dust collection?
- M
  Matthew YoungAug 21, 2025
  If your PowerTec Water Filtration System has poor air flow and dust collection, the filters may be dirty. Clean or replace both air filters frequently. Another cause may be poor system location in the shop. Reposition the system in the shop for best air circulation.

PowerTec AF4001 Specifications

General

Model	AF4001
HEPA Filter	Yes
Activated Carbon Filter	Yes
Noise Level	25-50 dB
Fan Speeds	3
Type	Air Purifier
Filtration System	3-stage
Filter Type	HEPA + Activated Carbon
Timer	Yes