3
ASSEMBLY
ASSEMBLY
3
Figure 3
Crank
Assembly
Crank
Make sure
the ruler is to
this side
Notches to
inside
Wood
Screws
• Orient the folding leg assemblies into the crank
assembly with the lower end of the brace on the
crank side.
• From the outside, insert bolts with one washer through
crank assembly and leg assembly and then on the
inside secure with the other washer and lock nut.
Tighten all hardware.
• Assemble the rubber feet to the legs. Each foot has
a long side. Assemble the long side to the outside of
the leg.
Long side
to outside
Lower end of
brace to the
crank side
Figure 4
Bolt
Washer
Washer
Nut
Folding Leg
Assemby
Crank
Assemby
Rubber
Foot
• Turn the stand over and press down the folding lock bar
to lock the legs in place.
• The bench dogs may now be assembled into any of the
holes on the table top. The bench dogs can be moved
when needed to aid in clamping the workpiece.
• Slots in the crossbars are for on board tool storage.
Figure 5
Bench Dog
Lock
Bar
Lock
Bar
• To fold the stand for storage, pull up on the folding lock
bar and press the front and back of the stand together.
Â
Á
¬
Figure 6
WARNING
Keep the stand dry, clean, and free from oil and grease.
Always use a clean cloth when cleaning. Never use brake
fluids, gasoline, petroleum based products or any strong
solvent to clean the miter saw stand . Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
To Next Page
Loading...
