6
5. “RECONDITION” Mode
A special mode to recondition your battery after the battery
has not been used for long time or after long deep discharge
that degrade the battery performance.
The Recondition mode may decrease the battery life hence consult your battery
vendor for advise if necessary.
6. “24V/STD/SLOW” Mode
Slow charge (Max. 2A Charging Current) with Standard or
GEL lead acid battery
7. “24V/STD/FAST” Mode
Fast charge (Max. 3.6A Charging Current) with Standard or
GEL lead acid battery.
8. “24V/AGM/DEEP/FAST” Mode
Fast charge (Max. 3.6A Charging Current) with AGM type
lead acid battery.
9. “POWER SUPPLY” Mode
voltage, with max. of 5A current.
START CHARGING YOUR BATTERY
PLEASE READ CAREFULLY BEFORE USING
Suitable for 12V and 24V Normal Lead Acid, Sealed, Lipo4, Leisure or Gel Bat-
teries between 5-150Ah for 12V batteries and 5-120Ah for 24V batteries.
1. PREPARING THE BATTERY
• Firstly remove the caps from each cell and check that the level of the liquid is
distilled water.
Note: Under no circumstances should tap water be used.
• The cell caps should not be replaced until charging is complete. This allows any
gases formed during charging to escape. It is inevitable that some minor escape of
acid will occur during charging.
For permanently sealed battery, it is not necessary to carry out the above checks.
2. CONNECTION
• Connect the positive charging lead (red) to the positive terminal post of the bat-
tery (marked P or +). Connect the negative charging lead (black) to the negative
terminal post of the battery (marked N or -).
Once you connected the MB3613 battery charger to AC power, it will sound
a tone for 0.5 seconds and all of the LEDs on the touch panel will be on for a
short time.
Warning! Always disconnect the AC plug from the AC mains socket before
connecting or disconnecting the appliance to or from the battery.
To Next Page
Loading...
