Need help?Do you have a question about the PowerTech PL500 and is the answer not in the manual?
General| Maximum Gate Weight | 500 kg |
|---|---|
| Opening Speed | 12 seconds per meter |
| Closing Speed | 12 seconds per meter |
| Operating Temperature | -20°C to 60°C |
| Manual Release | Yes |
| Safety Features | Obstacle detection |
Diagram showing the typical placement of the sliding gate motor, transmitter, safety photo sensor, and flashing light.
Identifies and describes the key components of the PL500 sliding gate opener unit.
Provides detailed measurements and specifications for the gate opener unit.
Illustrates the process of installing the motor gear and the corresponding gear rack onto the gate.
Details on how to check and verify the installation for proper functionality and alignment.
Step-by-step guide on how to manually release the motor in case of power failure.
Illustrates the proper wire connections for various components like transmitters and photocells.
Instructions for memorizing new transmitters and erasing existing ones from the system.
Guide to system learning, factory reset, and understanding LED display indicators.
Detailed explanation of various programmable functions and their settings for gate operation.
Procedures to test the gate opener after installation and setup for correct operation.
Configuration settings using SW2 and SW6 DIP switches for various functions.
Explanation of the meaning of different LED indications on the control board.
Detailed technical data sheet for the PL500 gate opener motor and its series.
Technical specifications for the PH-2 photocell safety sensor.
Technical specifications for the PR-1 remote control transmitter.
Technical specifications for the PF-1 flashing light indicator.
Technical specifications for the PRB-1 external receiver box.
Detailed guide for installing the safety photocells, including wiring and specifications.
Instructions for wiring and setting up the PRB-1 external receiver box for remote control.
To Next Page
