____________________________________________________________________________
Imported and distributed by Sadoun Satellite Sales,
www.sadoun.com 1-888-519-9595
To store the satellite positions:
1. After the DiSEqC1.2 receiver moves the actuator and stores the satellite
position, the display will automatically show the stored position number.
To recall a satellite position:
1. When you change the program from the receiver, the positioner
automatically moves the actuator to the stored position. But if the
position has not been stored, the positioner will not respond. Refer to
your receiver manual.
2. If the channels and satellites are properly set up in the receiver, it will
move the actuator to the proper position when you change the channel.
When the proper position is reached, the display will show the satellite
number as “01” ~ ”99”.
3. You can still operate the GBOX positioner from its IR remote if
necessary.
To re-synchronize satellite positions (re-calculate):
1. Not every DiSEqC1.2 receiver supports this re-sync function. If the
receiver has this function, the GBOX will carry out this command, but the
display won’t show any message.
2. If necessary, you may still use the GBOX IR remote to re-synchronize.
To operate from the front panel push buttons
1. Move the actuator East/West with the 3 and 4
buttons to the desired position. Press and hold the
power button for 5 seconds, and the display will
show ”C--_ _”.
2. Press the 3MANUAL4 buttons to scroll through
the position numbers on the display (1-99) and to
choose the satellite positions you want to store.
3. Within 2 seconds, press the “POWER” button for confirmation. The LED
will show the number you choose. (for example, “P03”)
To Next Page
Loading...
General