____________________________________________________________________________
Imported and distributed by Sadoun Satellite Sales,
www.sadoun.com 1-888-519-9595
Troubleshooting
Symptoms Check points
The Memorized Positions
are not correct.
• First, try re-sync to correct the position.
• If the symptom recurs repeatedly, replace the
reed sensor to see whether it is OK.
The LED displays |------ or
------| and can’t move
any
farther.
The symbols mean electrical limits, which have been set. To
cancel this setting, use the “Limit Off” function on the
receiver or press the limit key for more than 10 seconds.
The LED will show “|- - - - - -|” when it is clear.
The LED lights but the
positioner doesn’t work (no
response).
• Unplug the AC power. Wait for more than 10 seconds
then reconnect it.
• Unstable AC power can cause this problem. To
protect the stored data, the positioner will lock itself in
this situation. A voltage regulator or UPS might be
needed.
The manual 34 buttons
drive for only 1 count.
These buttons are for fine-tuning only, and the receiver
doesn’t support this function.
Specification
Input Voltage : 100-120VAC 60Hz
13 / 18 VDC (F Type via Coaxial Cable)
Output Voltage : 13 / 18 VDC (F Type / According to the Input)
36VDC (via Motor Cable)
Output Power : 60 W (Rated / Motor Cable)
Maximum Current : 3A
Power Consumption : 5W (Standby) 90W (Maximum)
Position Memories : 99
Protocol : DiSEqC 1.2
Operating
Temperature
:
5°C to 40°C (41°F to 104°F)
Storage Temperature :
-20°C to 60°C (-4°F to 140°F)
Dimensions (WxHxD) :
230x65x165 mm
3
(Net)/260x70x210 mm
3
(Gross)
Weight : 1.6 Kg (Net) / 1.8 Kg (Gross)
To Previous Page
Loading...
General