REPLACING GOBOS
ROTATING GOBO
ROTATED GOBO WHEEL
SPRING
ROTATED GOBO WHEEL
GOBO HOLDER
GOBO
RETAINING SPRING
Lock Tilt.
Free 2 latch catches on the cover and slip off the front cover. You could see the structure as shown in the above figure.
For gobos replacement on the rotated gobo wheel: take an appropriate tool to tug up spring and take out the rotating
gobo with its holder; tug the head of retaining spring up and engage your another hand to take the retaining spring out;
take the gobo out; fit a new gobo and fit the retaining spring; fit the gobo holder. Notes: the gobo cannot be touched with
bare hand; Be careful of the gobo when the replacement is underway and don’t drop it.
Close the front cover and fasten 2 latch catches.
CHANGING BELTS
Pan’s belts
Pan assmbly's
maintenance door
Screws
Screws
Free 2 screws on Pan assembly’s maintenance door and
pull the door; change the belts; close the door and fasten the
screws.
Tilt’s belts
The common user replacing the belts is not recommended.
9/18
To Next Page
Loading...
