Why is the beam dim on my PR Lighting Flood Light?
If the beam from your PR Lighting Flood Light appears dim, first check if the optics are clean. If cleaning doesn't resolve the issue, replace the lamp with a new one that matches the specified type and rating.
How to fix a PR Lighting XL 700 projector that doesn’t switch on?
If your PR Lighting Flood Light projector doesn’t switch on, start by checking the fuse on the power socket. If the fuse is fine, try replacing the lamp.
What to do if my PR Lighting XL 700 lamp comes on but the projector doesn’t respond to the controller?
If the lamp of your PR Lighting Flood Light comes on but the projector isn’t responding to the controller, ensure the projector is configured correctly. If the issue persists, replace or repair the DMX cable.
Why does the project image from my PR Lighting XL 700 Flood Light have a halo?
If the project image from your PR Lighting Flood Light appears to have a halo, ensure the lamp is installed correctly. Also, carefully clean the optical group lenses and the projector components.
How to troubleshoot defective projection on a PR Lighting XL 700 Flood Light?
If you're experiencing defective projection with your PR Lighting Flood Light, check the lenses for any breaks. Additionally, remove any dust or grease from the lenses.
Why does my PR Lighting XL 700 projector only function intermittently?
If your PR Lighting Flood Light only functions intermittently, make sure the fan is working and not dirty.
General| Control Protocol | DMX512 |
|---|---|
| IP Rating | IP20 |
| Pan | 540° |
| Tilt | 270° |
| Focus | Motorized |
| Dimmer | 0-100% |
| DMX Channels | 16 |
| Voltage | AC100-240V, 50/60Hz |
To Next Page
