PR Lighting XR440 BWS - Setup and Configuration; Front Panel Operation and Display; DMX Addressing and Wireless Setup; Stand-Alone Mode Operation

10/34
5. SETUP AND CONFIGURATION
● Front Panel Operation
W-DMXDMX
Projector configuration can be set conveniently via push button and LCD display.
Launch the projector and press button ENTER for more than 2 seconds to unlock the panel, the LCD will show the function menu of
the projector, each main menu has its submenus and each submenu has a specific function. For details, please see the
“OPERATION MENU” section.
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the submenu.
Press button UP or DOWN to change values(plus or minus)
Press button FUNC, it will return to the upper menu. If button FUNC not pressed, the default will show display status automatically.
● DMX START ADDRESS
Each XR 440 BWS must be given a DMX start address so that the correct projector responds to the correct control signals. This
DMX start address is the channel number from which the projector starts to “listen” to the digital control information being sent out
from the controller. The XR 440 BWS has 4 DMX modes. There are standard mode ,short mode .extended mode and compatible
mode. For example standard mode has 26 channels, so set the No. 1 projector’s address 001, No. 2 projector’s address 027, No. 3
projector’s address 053, No. 4 projector’s address079, and so on.
Launch the projector. Press button ENTER more than 2seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm; after powered on next time, the default will be last value saved
Press button FUNC, it will return to the upper menu
.
● DMX WIRELESS CONTROL (If the projector has the function)
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1. Enter into the projector’s menu. Select the menu “Wireless Options” via the bottoms of UP and DOWN
2. Select DMX control Mode---- Wireless First or Wireless Only (Note: do not select XLR ONLY)
3. Press FUNC to enter into the upper level menu ,select” Unlink Wireless” and press ENTER to confirm the
disconnection.
4. Let “Wireless Transmitter” send out signals and the “W-DMX” indication in the front panel of the base will be on,
which means the wireless control is activated. Only after the unit is connected with the wireless transmitter, can it
receive the wireless control signal.
● STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.