ProStar 27
Size of ProStar Logo
on Equipment
Equipment
The size of the ProStar logo must correlate
with the size of the equipment it appears
on. To ensure the ratio between logo and
equipment is correct, the diagrams on this
page illustrate the size the ProStar logo
should be based on the equipment size.
Refer to this diagram to determine
what size to make the ProStar logo on
equipment.
X
X
The area of non-interfer-
ence around the logo "X"
should be 1 1/2 the height
of the "P" in ProStar.
The logo should be proportionate with the
product/equipment size and location.
Always position the ProStar logo in the
upper center of the equipment, and the
uninterrupted space around the logo should
be 1 ½ the height of the “P” in ProStar.
The ProStar logo should always be one
third of the length of any equipment.
On equipment that is more than 72" long, a
24" long ProStar logo should be used. The
maximum size ProStar logo to be used on
equipment is 24" long.
The ProStar logo should be centered
whenever possible. If it cannot be centered,
it should be aligned in the upper left corner.
The ProStar logo should be
one third of the length of any
equipment.
1/3
1/3 1/3
To Next Page
Loading...
