5. Set the replacement power control module in its mounting position.
6. Install and tighten the four mounting screws.
7. Reconnect the COMM, INCLINE, INPUT, DB and OUTPUT connectors. The mating
connectors are keyed to insure proper contact pin alignment and fit.
8. Reinstall the hood.
9. Pug in the power cord and Switch the input power ON.
10. Verify treadmill operation (see Operation Verification) and return to service.
See Also
"Replacement Procedures" on page 48
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 78
6 Replacement Procedures
Power Control Module Replacement
To Next Page
Loading...
