Install the PVS on a Console
IMPORTANT
At least two people ar
e required to assemble the equipment.
Assembly requirements
• Remove the back cover from the console. This cover is not required as long as
the PVS is installed.
• If the console is attached to the equipment, remove the four console mounting
scr
ews that hold it in place and set them aside.
Attach the back plate to the PVS mounting bracket
Your hardware kit contains two back plates and screws.
• For all equipment except 800-Line Treadmills: Use the short back plate and short
5/16 x ¾-inch SHCS.
• For 800 Line Treadmills only: Use the long back plate and the long 5/16 x 3½-inch
SHCS.
To attach the back plate:
IMPORTANT
DO NOT str
etch, crimp, or damage the cables. Cables damaged by improper
installation are not covered by the Precor Limited Warranty.
1. Insert the screw through the mounting bracket into the back plate at least
three full turns.
IMPORTANT
Mak
e sure the screw is partially screwed into the back plate so that the back
plate does not fall into the equipment tube.
2. Fit the back plate into the neck of the equipment and turn it horizontally so
that it secur
es the mounting bracket against the equipment neck.
3. Place two screws into the PVS mounting bracket to align the holes with the
bottom plate, and then fully tighten the back plate scr
ew.
NOTE
Check the alignment of the PVS mounting bracket and gently tap the
bracket to the left or right to align it.
13
To Next Page
Loading...