Assembling the Exercise Bike 37
6. Insert four ¹₄-inch x ³₄-inch buttonhead screws through
the screw holes in the tabs on the mounting bracket and
into the screw anchors on the console. Tighten the screws
completely using a ⁵₃₂-inch hex wrench.
7. Lower the rear cover over the mounting bracket so that
the upright support extends through the gap in the cover.
Figure 18: Rear cover position
8. Position the back cover and attach the four 1-inch
panhead machine screws, then tighten the screws
completely using a #2 Phillips screwdriver.
Figure 19: Reattaching rear cover screws
To Next Page
Loading...
