Need help?Do you have a question about the Precor SBK867 and is the answer not in the manual?
General| Brand | Precor |
|---|---|
| Model | SBK867 |
| Category | Exercise Bike |
| Language | English |
Automatic calibration feature to remove strain gauge sensor errors.
Procedure to adjust magnetic brake pads for proper resistance level.
Procedure to verify and adjust drive belt tension and tracking.
Procedure to verify and adjust generator belt tension.
Procedure to determine battery condition and replace it.
Procedure to remove and install the magnetic brake pads.
Procedure to remove and install the brake caliper assembly.
Procedure to remove and install the Data COMM cable.
Procedure to remove and install drive belt, generator belt, and flywheel.
Procedure to remove and install the Generator Assembly.
Procedure to remove and install the Handlebar Assembly.
Procedure to remove and install the LPCA board.
Procedure to remove and install the Pedals.
Procedure to remove and install the Crank Arm.
Procedure to remove and install the Resistance Knob assembly.
Procedure to remove and install the Seat Assembly.
Discussion on calibration process and common wattage measurement fluctuations.
Guidance to review before performing machine service.
To Next Page
