4. Position the crank arm to the 9 o'clock position and then carefully slide the front cover
over the crank arm and pedal to remove. Retain part(s) and/or fastener(s) for install-
ation.
Installation Instructions
1. Position the crank arm to the 9 o'clock position and then carefully slide the front cover
over the pedal and crank arm. Retain part(s) and/or fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 49
5 Replacement Procedures
Belt Guard Cover Replacement
To Next Page
Loading...
