13. If the axle nuts were not previously tightened to specification, tighten the left and right
axle nuts torque to 29.5 ft-lbs (40 Nm).
14. Adjust the generator belt tension to 1/4 in (6.5 mm) belt deflection, see "Generator
Belt Tension Adjustment" on page35 .
15. Install the left and right brake pads and adjust the brake pad gap to specification, see
"Brake Pad Replacement" on page52.
16. Replace front and rear belt guard covers in reverse order, see "Belt Guard Cover
Replacement" on page47.
17. Verify the bike operation per "Operation Verification Checklist" on page14 and return
to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 97
5 Replacement Procedures
Drive Belt, Generator Belt, and Flywheel Replacement
To Next Page
Loading...
