4. Cut the cable tie that is securing the battery to the cross member and remove the bat-
tery.
Installation procedure.
1. Place the battery on the cross member and secure with an 8" cable tie.
2. Carefully reconnect the battery cable Red wire to the Positive (+) battery terminal and
then the Black wire to the Negative (-) battery terminal. Reconnect the Negative ter-
minal cable last.
3. Slowly pedal the bike enough to power ON the console, access the console service
test menu BAT VOLT parameter (see "Spinner® Chrono™ Console" on page177).
Continue pedaling and verify that the battery voltage is between 6.0 - 7.5 Vdc, then
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 45
5 Replacement Procedures
Battery Replacement
To Next Page
Loading...
