3. Remove the slider travel limit set screw located on the underside of the seat slider using
a 2.5 mm hex key. Retain fastener hardware for installation.
4. Remove seat slider assembly by moving it towards the front of the bike.
5. Reinstall the replacement seat slider in reverse order.
6. Verify the seat slider forward/reverse travel is smooth and is blocked from sliding off the
seat post.
7. Verify that the seat fwd/aft adjustment knob works properly and return to service.
Seat post replacement instructions
1. Pull the seat height adjustment pop-pin and remove the seat post from the frame.
1. Clean and apply a thin film of 3-IN-ONE SILICONE lubricant onto the seat assembly
post. Do not apply lubricant to the seat forward/back slider.
2. Reinstall the seat post by pulling the height adjustment pop-pin and inserting the post
into the bike frame. Release the pop-pin so that it engages inside the seat post.
3. Verify that the seat height adjustment works properly and return to service.
See Also
"Replacement Procedures" on page16
51
To Next Page
Loading...
Need help?
General
