Page 9For technical questions, please call 1-888-866-5797.ITEM 60622
SAFETYSETUPOPERATIONMAINTENANCE
Fill the Gearbox
IMPORTANT! Your warranty is voided if you operate the Auger without the proper amount
of SAE 80-90 gear oil in its Gearbox. Do not run the Auger with low or no gear oil.
Running the unit with low or no gear oil will permanently damage the unit.
1. Remove the Oil Fill Plug.
2. Wipe top of Gearbox with a clean cloth.
3. Remove Gearbox Fill Level Plug and
add oil through the Oil Fill Level Plug until it
reaches the Gearbox Fill Level Plug hole.
Note: The Auger must be vertical when
adding gear oil to assure proper oil level.
4. Wipe up any spilled oil.
5. Replace the Oil Fill Plug and tighten securely.
NOTICE: Do not use dirty, used, or otherwise
contaminated gear oil. Damage may occur to
the internal mechanisms of the Gearbox.
NOTICE: Do not run the Auger with too little or
too much oil. The Auger will be permanently damaged.
Installing Bit
1. Insert the shank of the Bit fully upward into the
Transmission Socket on the bottom of the Auger.
2. Secure the Bit in the Transmission
Socket, using the Pin and R-Pin.
To Next Page
Loading...
Need help?
General
