Page 13For equipment technical questions, please call 1-888-866-5797.ITEM 64931
SAFETYSETUPOPERATIONMAINTENANCE
Starting the Engine
Before Starting the Engine
a. Inspect the equipment and engine.
b. Fill the engine with the proper amount and type of
both stabilizer-treated unleaded gasoline and oil.
c. TURN ON WATER SUPPLY, REMOVE NOZZLE, POINT WAND IN SAFE DIRECTION, AND HOLD
DOWN TRIGGER FOR 1 MINUTE UNTIL ALL AIR IS RELEASED FROM THE SYSTEM.
Then release Trigger, lock in the safety position and replace Nozzle before starting engine.
Manual Start
1. Turn Pressure Regulator counterclockwise
to reduce pressure in the system.
2. To start a cold engine, move the Choke to the
START position.
To restart a warm engine, leave the
Choke in the RUN position.
3. Open the Fuel Valve.
4. Slide the Throttle to 1/3 away from the
SLOW position (the “turtle”).
1
2
3
4
To Next Page
Loading...
