Page 14 For equipment technical questions, please call 1-888-866-5797. ITEM 64931
SAFETY SETUP OPERATION MAINTENANCE
5. Turn the Engine Switch on.
6. Grip the Starter Handle of the Engine loosely and pull
it slowly two times to allow the gasoline to flow into
the Engine’s carburetor. Then pull the Starter Handle
gently until resistance is felt. Allow Cable to retract fully
and then pull it quickly. Repeat until the engine starts.
Note: Do not let the Starter Handle snap back against the
engine. Hold it as it recoils so it doesn't hit the engine.
If engine does not start, check engine oil level.
Engine will not start with low or no engine oil.
7. Allow the Engine to run for several seconds.
Then, if the Choke lever is in the START position,
move the Choke Lever very slowly to its RUN position.
Note: Moving the Choke Lever too
fast could stall the engine.
Break-in Period:
a. Breaking-in the engine will help to ensure proper equipment and engine operation.
b. The operational break-in period will last about 3 hours of use. During this period:
• Do not apply a heavy load to the equipment.
• Do not operate the engine at its maximum speed.
c. The maintenance break-in period will last about 20 hours of use.
• Change the engine oil after this period.
Under normal operating conditions subsequent maintenance follows
the schedule explained in the MAINTENANCE section.
ON
OFF
ON
5
OFF
ON
6
7
Starting the Engine (continued)
To Next Page
Loading...
