2) Sort Mode
This mode is available by pressing the MODE button until “SDC’’ is displayed on the home
screen.
SORT mode allows the user to count the value and quantity of banknotes sorted per
denomination. Denominations that are different than the first counted banknote will be rejected
by machine.
3) Count Mode
This mode is available by pressing the MODE button until “CNT’’ is displayed on the home
screen.
COUNT mode allows the user to simply count the total number of bills. It does not
recognize or record the denomination of any bills. During COUNT mode, there is no
counterfeit detection active.
4) Automatic / Manual Counting Start Mode
After turning the machine on it will default to automatic counting mode, an “AUTO’’ will be
displayed on the home screen. In this mode the machine starts counting automatically.
To operate with the manual counting mode, by pressing the A/M button, “AUTO’’ indicator will
be off. In this mode, the machine will stop counting automatically, the “RESTART’’ button must
be pressed to begin each count.
5) Batch Mode
This mode is available by pressing the BATCH button on the control panel. By default,
pressing the BATCH button will set the batch number to 100, then continue to press the
BATCH button, 50, 0 will be displayed in turn. Press “←” button to increase the batch number
by 10, press “→” button to decrease the batch number by 10, Press “↑” button to increase
the batch number by 1, press “↓” button to decrease the batch number by 1, press ESC button
to exit the BATCH mode.
BATCH mode is used to select a batch quantity for a specific counting process. With the
BATCH mode active, the machine counts a preset number of bills and then stops counting
when the batch number has been reached, even if bills remain in the hopper. When the
banknotes are removed from stacker, the machine will automatically continue to count up to
the preset batch number to create another batch.
6) Add Mode
This mode is available by pressing the ADD button on the control panel. The ADD function is
used to add the counting results of multiple counts to the total. When ADD mode is activated,
an ADD icon will be displayed on the home screen. To exit ADD mode, press again the ADD
button.
9.3 Serial Number Scanning
To Next Page
Loading...
Need help?
General