PSD-BW/L
Installation Instructions Page - 4 -
Parts List
Congratulations on purchasing the PSD-BW/PSD-BWL Nesting Cart. The PSD-BW/PSD-BWL Nesting Cart is
shipped with all proper installation hardware and components. Please verify that none of these parts are missing
and/or damaged before assembly. If there are parts missing and/or damaged, please stop the assembly and
contact Premier Mounts (800) 368-7000.
NOTE: Some mounting configurations will allow for a “landscape” orientation. In these situations, when
moving the PSD-BW/L Nesting Cart through a doorway, the orientation of the display must be
returned to the “portrait” orientation. If not, maneuvering through the doorway could prove costly by
damaging the display.
BW Base (Qty 1)
PSD-SPA (Qty 1)
3” Castors (Qty 4)
(2 locking,
2 non-locking)
M8 x 10mm Set Screws
(Qty 6)
Support Tubes
(Qty 2)
NOTE
: Length will
vary depending on
model purchased.
M10 Flat Washers
(Qty 4)
M10 x 12mm Hex
Head Screws
(Qty 4)
21mm Caster Wrench
(Qty 1)
Installation Tools
Socket head wrench Soft Material/ Blanket
M5 Allen Wrench (Supplied) 5/32” Allen Wrench (Supplied)
To Next Page
Loading...
