RTM-L
Page 8 Installation Instructions
NOTE: The installation instructions that are contained in this manual refer only to the RTM-L. The
installation instructions for the various bases that are used with the RTM-L will be included with
those products.
NOTE
: Prior to installing the RTM-L, the mounting configuration must already be assembled (base,
support poles, etc.).
Mount Installation
Set Screws
1. Slide the mounting block
over and down the support
poles.
2. To secure the mounting block to the support
poles, tighten the four set screws (located on
each side of the mounting block), using the
5/32" Allen wrench (supplied).
Mounting
Block
Cradle
Support
Poles
To Next Page
Loading...
