CONVERTING RANGE FROM PROPANE GAS TO
NATURAL GAS
IMPORTANT: READ PRIOR TO STARTING THE CONVERSION PROCESS: Because your r ange may
be fitted with one of three different types of oven systems, it is necessary to determine which system the range em-
ploys in order to be successful making the range conversion. These instructions provide two different methods for
converting the range from Propane Gas to Natural Gas, Method A or Method B. Use the following guidelines to
determine which method to use for conversion:
If the range has a “PILOT” or “LITE” setting on the oven thermostat control use
Method A.
If the range does not have a “PILOT” or “LITE” setting on the oven thermostat
control use Method B.
PILOT
WARNING: TO AVOID THE RISK OF SERIOUS PERSONAL INJURY OR PROPERTY DAMAGE, THE
RANGE MUST BE CONVERTED CORRECTLY. IMPROPER CONVERSION OR FLAME ADJUST-
MENT WILL PRODUCE CARBON MONOXIDE, WHICH IS A POISONOUS GAS.
STEP 1 METHOD A or METHOD B Convert Regulator
from Propane Gas to Natural Gas:
Remove range main top. See Page 11 for main top removal..
A. Remove cap from regulator and snap out plastic plunger
from bottom of cap. See Fig. 2
B. Turn plunger over and snap back into the same location.
C. Re-insert cap into regulator and screw in place.
REGULATOR
NATURAL GAS POSITION
STEP 2 METHOD A or METHOD B Convert Range Top Bur ner s:
1. Each top burner must be adjusted to the Natural setting. With a 1/2” open end wrench rotate the
orifice hood clockwise two full turns on the valve. The orifice hood is the brass hood on the
end of top burner valve. See Fig. 3
2. Repeat this procedure for
each of the remaining top
burner valves.
ORIFICE HOOD
TOP BURNERS
Fig. 3
CAP
25
Fig. 1
Fig. 2
To Next Page
Loading...
