Step 5:
Factory has pre-set the Pre-Stretch before shipment so while switching on the machine by
pressing the Power Switch on the side panel, the LED will display “F12”. If the LED doesn’t
display “F12”, to attain the Pre-Stretch function, switch off the machine by pressing the Power
Switch on the side panel first. Second, turn on the Pre-Stretch Select Switch. Third, switch on the
machine by pressing the Power Switch again and then the L.E.D will display “F12” at start up.
To pull the string without Pre-stretch function, switch off the machine by pressing the Power Switch
on the side panel first. Second, turn off the Pre-Stretch Select Switch. Third, switch on the machine
by pressing the Power Switch again and
then the L.E.D. will display “F02” at start up.
To Next Page
Loading...
