PRESONUS Central Station Plus - Line Outputs 线路输出

23
Owner’s Manual
Controls and Connections
5
5.2.4 Line Outputs 线路输出
These outputs are ideal for connecting external headphone-
distribution systems or external mastering units. Again, only
balanced cables should be used when connecting your Central
Station to these devices. Because of the Central Station’s passive
circuitry, using unbalanced cables can reduce the output level and
can introduce noise into your system.
这些输出是连接外部耳机分配系统或外部母带装置的理想选择。同
样，在连接Central Station 和这些设备时，应该只使用平衡电缆。由
于Central Station 的无源电路，使用不平衡的电缆会降低输出电平，
并可能将噪音引入你的系统中。
• Main (L/R) . Connect this stereo pair of left (L) and right (R),
line-level, ¼”balanced TRS outputs to a recording device.
There is no attenuator (volume control) on this output.
• Cue(L/R). Connect this stereo pair of left (L) and right (R), line-level,
¼”balanced TRS outputs to a headphone-distribution amplifier.The
front-panelCue Output Level adjustment controlsvolumelevel.
Main (L/R). 将这对立体声的左(L)和右(R)，线路电平，¼"平衡
TRS 输出连接到录音设备。在这个输出上没有衰减器（音量控
制）。
Cue(L/R). 连接这对立体声的左(L)和右(R)，线路电平。¼"平
衡TRS输出连接到一个耳机分配放大器。前面板上的提示输出
电平调整控制音量大小。
Technical Information
C
C
o
o
n
n
t
t
r r
o
o
l
l
s
s
a
a
n
n
d
d
C
C
o
o
n
n
n
n
e e
c
c
t
t
i
i
o
o
n
n
s
s