Table of Contents
1.0 Overview — 1
1.1 Introduction — 1
1.2 What’s In The Box — 2
1.2 Register your Studiolive RML-series mixer! — 3
1.3 Download UC-Surface foriPad® and Qmix
™
-Ai — 3
1.4 Update all Firmware and Software — 3
2.0 Networking the RML-series mixer — 4
2.1 IP Address Modes — 4
2.2 Wired Ethernet Control Setup — 4
3 Making the Connections — 5
3.1 Mixer Anatomy — 5
3.2 Single RML Mixer Setup — 6
3.3 Cascading RML Mixer Setup — 7
3.3.1 RML Mixers with UC Surface — 7
3.3.2 RML Mixers with CS18AI and UC Surface — 8
3.3.3 Connecting a computer for recording/playback — 9
3.3.4 Turning on Cascading — 10
4.0 Getting Started with UC-Surface — 11
4.1 Anatomy of the UC-Surface Screen — 11
4.1.1 Connected device tabs. — 12
4.1.2 Settings button. — 12
4.1.3 Fat Channel Area — 13
4.1.4 Presets Button — 14
4.1.5 Channel Strip Area — 14
4.1.6 Flex Master Channel Strip — 15
4.1.7 Mix Selection Area — 15
4.1.8 Main Output Area — 16
4.1.9 Input Meter Bridge and Navigation — 16
To Next Page