Prestan PP-AEDT-101 - Trouble Shooting Guide; Module and Power Issues; Pad and Lid Difficulties; Device Analysis and Remote Problems

Prestan professional
AED TRAINER
COPYRIGHT 2012 PRESTAN PRODUCTS LLC 11 Rev. 101812
Trouble Shooting Guide
SYMPTOM
POSSIBLE ISSUES OR COMMENTS
SOLUTIONS
Module will not fit into
slot
•
The Module is designed to be inserted one
way only
•
Rotate the Mod
ule 180 degrees and it
will fit
Unit Does Not
Turn On
• Module is missing or not fully inserted
• Batteries are not property installed
• Batteries are dead or are missing
• Insert or Re-insert module properly
• Re-orient batteries properly
• Replace batteries
Difficult to Peel Off the
Pads Liner
• Peel the liner from the Tab End
• Gently bend over the Connector to start
separation
• Peel with thumb if necessary
•
Remove and throw away liner
• Refer to the Assembly Section
Both pads attached to
Manikin but
device will not advance to
Analysis
•
Operational solution
• Pad is inserted upside down in the cable
connector.
• Adhesive worn out
•
Insure Pads are being pressed on
firmly
•
Flip pad around and secure with black
pad pin
• Replace pad
Pad pulls out from pad
connector
• Check for black pad pin missing • Install new black pad pin
Lid will not stay closed
• Pads Case is not placed in proper position
• Re-seat pads case
• Wires not properly stored in compartment
under Case - Wire may be caught under
edge of Pads Case
• Re-coil the wires
• Pads Case Front & Back not properly closed
• Snap case together on all 4 corners
Device Proceeds to
Analyzing before
both pads have been
placed on the
manikin
• Pads not properly positioned in Case
• Look for pad riding up pad case wall
• Re-position pad in case to lay
completely flat so it is not touching
side walls