Care and Cleaning
TURN OFF THE HOB ELECTRICITY SUPPLY BEFORE CLEANING.
VITREOUS ENAMEL
Burner caps, pansupports.
Use a cloth wrung out in hot soapy wa t e r. Stubborn stains can be re m oved with a cre a m
paste approved by the Vit reous Enamel Development Council, liquid cleaner or by rubbing
w ith soap filled pads.
STAINLESS STEEL
Hot plate spillage tray, Hotplate burner bodies.
It is advisable to clean the spillage tray regularly to pre vent any build up of soiling which
m a y detract from the appearance of the appliance. The recommended method of cleaning is
to wipe over the entire spillage tray with a soft cloth wrung out in warm wa t e r, or mild non-
a b r a s i ve cleaner. (If in doubt try the cleaner on a small area which is not noticeable in
normal use), then after wiping with a cloth wrung out in clear wa t e r, dry with a soft clean
c l o t h .
Use a nylon brush to re m ove any cleaning materials, water or dirt from the hotplate burner
bodies. After cleaning, wipe dry and re f i t to the hob ensuring they are corre c t ly seated.
Check parts are reassembled corre c t ly by lighting the burners and allowing to dry out.
P L A S T I C
Control knobs
.
Wipe with a cloth wrung out in hot soapy wa t e r.
3
Zepa GH60.qxd 19/9/07 8:55 Page 5
To Next Page
Loading...